Installation Procedure

WARNING: This page is about a different car, the 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.

Position the engine mount strut bracket over the upper radiator support. Make sure that the engine mount strut bracket and the engine mount strut are aligned to the proper holes of the upper radiator support. The proper torque sequence is shown (1,2).
Install and tighten the engine mount strut bracket bolts. The following is a mandatory torque sequence:
1. 2.1. Tighten the horizontal engine mount strut bracket bolt (1) to the engine mount strut bracket.
  Tighten:
  
  Tighten the horizontal engine mount strut bracket bolt to 26 N.m (19 ft lbs)
  
  Fig 1: Installing Engine Mount Strut Bracket Bolts
  Courtesy of GENERAL MOTORS CORP.
2. 2.2. Tighten the vertical engine mount strut bracket bolts (2) to the engine mount strut bracket.
  Tighten:
  
  Tighten the vertical engine mount strut bracket bolts to 26 N.m (19 ft lbs)
Install the engine mount strut to the engine mount strut bracket at the upper radiator support. Refer to Engine Mount Strut Bracket Replacement - Left or Engine Mount Strut Bracket Replacement - Right .