LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 363 (Removal & Installation - A/T (AF33-5)) >> Removal & Installation >> Rear Mount Bracket >> Removal

Rear Mount Bracket: Removal

WARNING: This page is about a different car, the 2002 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Disconnect the stabilizer link from the stabilizer shaft. See Fig 1 .
  3. Remove the lower intermediate steering shaft pinch bolt. See Fig 2 . Discard the bolt.
  4. Disconnect the intermediate steering shaft from the steering gear.
  5. Disconnect the left outer tie rod from the steering knuckle. See appropriate FRONT article in SUSPENSION.
  6. Remove the steering gear mounting bolts. See Fig 3 .
  7. Secure the steering gear upward for clearance.
  8. Remove the rear transaxle mount. See REAR MOUNT  .
  9. If equipped with FWD, remove the rear transaxle mount bracket to transaxle bolts. See Fig 4 .
  10. If equipped with AWD, remove the rear transaxle bracket to power takeoff bolts. See Fig 5 .
  11. Remove the rear transaxle mount bracket.
Fig 1: Disconnecting Stabilizer Link From Shaft
G00210857Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing/Installing Steering Gear Pinch Bolt
G00199864Courtesy of GENERAL MOTORS CORP.
Fig 3: Removing Steering Gear Mounting Bolts
G00210856Courtesy of GENERAL MOTORS CORP.
Fig 4: Removing Rear Transaxle Mount Bracket Bolts (FWD)
G00210855Courtesy of GENERAL MOTORS CORP.
Fig 5: Removing Rear Transaxle Bracket Bolts (AWD)
G00210854Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals