Hub & Bearing Assembly: Installation
WARNING: This page is about a different car, the 2002 Pontiac Grand Am, 2002 Oldsmobile Alero, and 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
To install, reverse removal procedure. Lubricate caliper pins and pin boots with Silicone Grease (GM 18010908), or equivalent, when installing. Use NEW caliper bracket bolts. Clean metal contact surfaces between brake rotor and hub/bearing flange. Tighten all fasteners to specification. See TORQUE SPECIFICATIONS . Check wheel alignment. See appropriate SPECIFICATIONS & PROCEDURES article in WHEEL ALIGNMENT.