LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 359 (Engine Controls - Removal & Installation, Overhaul) >> Sensors >> Knock Sensors >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. The Knock Sensors (KS) are located underneath the intake manifold. See Fig 1. Remove the intake manifold. See appropriate article in ENGINES.
  2. Remove the KS wiring harness assembly. Remove the KS from the engine block. To install, reverse removal procedure. Tighten KS to specification. See TORQUE SPECIFICATIONS .
  3. Check if keyless entry transmitters function properly. If transmitters do not function properly, reprogram transmitters. See KEYLESS ENTRY TRANSMITTER SYNCHRONIZATION  under PROGRAMMING.
Fig 1: Locating Knock Sensors
G00113383Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals