LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 359 (Engine Controls - Removal & Installation, Overhaul) >> Fuel Systems >> Fuel Sender (Without Feedback Fuel System) >> Removal (Left Sender)

Removal (Left Sender)

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release fuel system pressure. See FUEL SYSTEM PRESSURE RELEASE .
  2. Raise and support the vehicle. Remove the left or right rear wheel and tire assembly. Clean all of the fuel connections and the surrounding areas before disconnecting the fuel pipes in order to avoid possible contamination of the fuel system.
  3. Drain the fuel tanks. See FUEL TANK DRAINING . Remove the fuel tank shield. Mark or identify each fuel pipe in order to aid in installing the pipes in their original positions.
  4. Disconnect the quick-connect fittings from the fuel sender. See FUEL LINE DISCONNECT FITTINGS . Cap all of the fuel pipes. Disconnect the fuel sender electrical connector. Remove the fuel tank strap.
  5. Support the fuel tank. Remove the fuel sender attaching bolts. Remove the float arm retaining clip and the float arm for the left fuel sender only. Carefully remove the fuel sender with the gasket. Clean the gasket sealing surfaces.
scientia non olet · About LEMON Manuals