LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 356 (Automatic Transmission Servicing) >> Removal & Installation >> Shift Cable >> Installation

Shift Cable: Installation

WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Push the cable down through the floor panel and install the grommet (2). See Figure .
  2. Install the range selector cable (2) to the floor shift control assembly. See Figure .
  3. Install the end of the range selector cable (1) to floor control ball stud.
  4. Install the drivers side front mat and carpet.
  5. Install the console.
  6. Raise and support the vehicle.
  7. Install the cable to the retainer (3) on the floor panel. See Figure . If the vehicle is equipped with 4WD, install the cable to the retainers located on the transfer case.
  8. Install the range selector cable (4) to the bracket (1).
  9. Install the retainer (5) to the range selector cable.
  10. Install the end of the range selector cable to the transmission range selector lever ball stud (6).
  11. Adjust the range selector cable.
  12. Lower the vehicle and check for proper operation.
scientia non olet · About LEMON Manuals