LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 356 (Automatic Transmission Servicing) >> Removal & Installation >> 2-4 Servo >> Installation

2-4 Servo: Installation

WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the new seals on the pistons and the servo cover.
  2. Install the 2-4 servo assembly into the transmission.
  3. Install the servo cover depressor.
  4. Tighten the bolt on the servo cover depressor to compress the servo cover. See Figure .
  5. Install the servo cover retaining ring.
  6. Remove the servo cover depressor from the oil pan flange.
  7. Install the oil pan bolt. Tighten the oil pan bolt to specification. See TORQUE SPECIFICATIONS  .
  8. Install the heat shield. Install the 2 bolts securing the transmission heat shield to the transmission. Tighten the heat shield bolts to specification. See TORQUE SPECIFICATIONS  .
  9. Install the exhaust pipe assembly.
  10. Install the transmission support.
  11. Remove the transmission jack.
  12. Lower the vehicle.
  13. Fill transmission with appropriate fluid to proper level. See LUBRICATION  .
scientia non olet · About LEMON Manuals