LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 356 (Automatic Transmission Servicing) >> Lubrication >> Draining & Refilling >> Refilling

Draining & Refilling: Refilling

WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Coat the new filter seal with automatic transmission fluid.
  2. Install the new filter seal into the transmission case. Tap the seal into place using a suitable size socket. See Fig 1 .
  3. Install the new filter into the case.
  4. Install the oil pan and a new gasket.
  5. Install the oil pan bolts. Tighten the oil pan bolts alternately and evenly to specification. See TORQUE SPECIFICATIONS  .
  6. If previously removed, install the shift cable bracket and bolts. Tighten the bolts to specification. See TORQUE SPECIFICATIONS  .
  7. Apply a small amount of sealant to the threads of the oil pan drain plug, if equipped.
  8. Install the oil pan drain plug, if equipped. Tighten the oil pan drain plug to specification. See TORQUE SPECIFICATIONS  .
  9. Lower the vehicle.
  10. Fill transmission with appropriate fluid to proper level. See RECOMMENDED FLUIDS  and FLUID CAPACITIES  .
  11. Check the COLD fluid level reading for initial fill only.
  12. Inspect the oil pan gasket for leaks.
Fig 1: Installing Oil Filter Seal
G00056981Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals