Vehicle Speed Sensor: Removal

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support the vehicle.
Remove the harness connector.
Remove the bolt.
Using a twisting and pulling motion, remove the vehicle speed sensor (1) from the case. See Fig 1.
Remove and discard the "O" ring seal (3).

Fig 1: Removing & Installing VSS

Courtesy of GENERAL MOTORS CORP.