LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 350 (Automatic Transmission Servicing) >> Removal & Installation >> Shift Cable (Floor Shift) >> Installation

Shift Cable (Floor Shift): Installation

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the cable through the opening in the floor panel. See Figure.
  2. Install the grommet to the floor panel.
  3. Install the sound deadening material that covers the cable.
  4. Install the cable to the controller. See Figure.
  5. Install the retainer securing the cable to the controller.
  6. Connect the cable end to the controller ball stud.
  7. Install the front mat and carpet.
  8. Install the console. See REMOVAL & INSTALLATION in appropriate SHIFT INTERLOCK SYSTEMS article.
  9. Ensure that the shift controller is in the Neutral position.
  10. Raise the vehicle.
  11. Install the range selector cable to the bracket.
  12. Install the retainer (1) to the range selector cable and transmission bracket. See Figure.
  13. Ensure that the transmission range selector lever is in the Neutral position.
  14. Following the adjustment procedure, install the range selector cable (2) to the range selector cable lever ball stud (1). See Figure.
  15. Install the positive assurance pin to the bracket.
  16. Install the transfer case shield, if equipped.
  17. Lower the vehicle and check for proper operation. Repeat the adjustment procedure if necessary. See SHIFT CABLE .
scientia non olet · About LEMON Manuals