LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 350 (Automatic Transmission Servicing) >> Removal & Installation >> Park/Neutral Position Switch >> Removal

Park/Neutral Position Switch: Removal

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply the parking brake.
  2. Shift the transmission into Neutral.
  3. Raise and support the vehicle.
  4. Remove the nut securing the transmission control lever to the manual shaft.
  5. Remove the transmission control lever from the manual shaft.
  6. Disconnect the electrical connectors from the switch.
  7. Remove the bolts securing the PNP switch to the transmission.
  8. Remove the PNP switch from the manual shaft. See Fig 1. If the PNP switch did not slide off the manual shaft, file the outer edge of the manual shaft to remove any burrs.
Fig 1: Removing & Installing Park/Neutral Position Switch
G00088349Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals