LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 350 (Automatic Transmission Servicing) >> Removal & Installation >> Filler Tube >> Installation

Filler Tube: Installation

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a new seal into the transmission case.
  2. Install the filler tube into the seal.
  3. Install the bolt securing the filler tube to the transmission torque converter housing. See Figure. Tighten the bolt to specification. See TORQUE SPECIFICATIONS .
  4. Raise the transmission.
  5. Install the transmission support and remove the jack. See Figure.
  6. If the vehicle is equipped with a 2.2L engine, proceed to step  8.
  7. Install the rear drive shaft. See appropriate DRIVE SHAFTS & UNIVERSAL JOINTS article in DRIVELINE/AXLES.
  8. Install the exhaust manifold pipe.
  9. Lower the vehicle.
  10. On 2.2L models, install the bolt securing the dipstick to the exhaust manifold. See Figure. Tighten the bolt to specification. See TORQUE SPECIFICATIONS .
  11. Install the transmission oil level indicator.
  12. Fill transmission with appropriate fluid to proper level. See LUBRICATION .
scientia non olet · About LEMON Manuals