LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Automatic Transaxle Overhaul & Testing - 4T65-E) >> Transaxle Disassembly >> Reverse Band Servo

Reverse Band Servo

WARNING: This page does not describe the selected car, but rather 43 other vehicles, including the 2003 Pontiac Montana, 2003 Pontiac Grand Prix, 2003 Pontiac Bonneville, 2003 Pontiac Aztek, and 2003 Oldsmobile Silhouette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using long screwdriver, depress reverse band servo cover by prying against holding fixture. Pry retaining ring from reverse band servo cover. See Fig 1.
  2. Remove screwdriver. Servo assembly will push servo cover up. Using small screwdriver, pull servo cover "O" ring seal out through slot in case. Cut servo "O" ring seal. Depress reverse band servo cover. Grasp one end of cut seal and pull from servo cover. Servo assembly will push servo cover up. Remove servo cover, reverse band servo assembly and reverse band servo piston return spring. See Fig 2.
Fig 1: Removing & Installing Reverse Servo Assembly Cover
G00057600Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing & Installing Reverse Servo Assembly
G00073385Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals