LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Automatic Transaxle Overhaul & Testing - 4T65-E) >> Transaxle Disassembly >> Output Shaft

Output Shaft

WARNING: This page does not describe the selected car, but rather 43 other vehicles, including the 2003 Pontiac Montana, 2003 Pontiac Grand Prix, 2003 Pontiac Bonneville, 2003 Pontiac Aztek, and 2003 Oldsmobile Silhouette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove case extension bolts. Remove case extension and extension seal. See Fig 1. Leave front differential carrier thrust washer and bearing on carrier. Rotate differential carrier until differential carrier pinion shaft is in horizontal position.
  2. Place Axle Remover Wedge (J 42562) between end of output shaft and differential pinion shaft. Using hammer, strike axle removal wedge to compress snap ring and push output shaft from differential side gear. See Fig 2. Remove differential carrier assembly and snap ring from output shaft. See Fig 3. Remove output shaft assembly. See Fig 4.
Fig 1: Removing & Installing Case Extension
G00057607Courtesy of GENERAL MOTORS CORP.
Fig 2: Compressing Output Shaft Snap Ring
G99G54979Courtesy of GENERAL MOTORS CORP.
Fig 3: Removing Differential Carrier Assembly
G00057608Courtesy of GENERAL MOTORS CORP.
Fig 4: Removing Output Shaft
G00057609Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals