LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Automatic Transaxle Overhaul & Testing - 4T65-E) >> Transaxle Disassembly >> Input & 2ND Clutch Assemblies

Input & 2ND Clutch Assemblies

WARNING: This page does not describe the selected car, but rather 43 other vehicles, including the 2003 Pontiac Montana, 2003 Pontiac Grand Prix, 2003 Pontiac Bonneville, 2003 Pontiac Aztek, and 2003 Oldsmobile Silhouette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Adjust collar on Final Drive/Clutch Remover/Installer (J-33381-A) to ensure threaded rod is fully loosened. Install Remover/Installer into 2nd clutch housing assembly. Tighten threaded rod until rod is finger tight. Lift up on remover/installer with 2nd clutch and input clutch assemblies attached. Sprag clutch assemblies will also be attached. See Fig 1.
  2. Place complete assembly on bench. Loosen threaded rod and remove remover/installer. Lift 2nd clutch housing assembly off input clutch housing. Remove input clutch housing thrust bearing from input housing. Remove selective thrust washer from input clutch housing. See Fig 2.
Fig 1: Removing & Installing Input & 2nd Clutch Assemblies
G99A54981Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing & Installing 2nd Clutch Housing
G00057616Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals