LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Automatic Transaxle Overhaul & Testing - 4T65-E) >> Component Disassembly & Reassembly >> Left Axle Shaft Oil Seal >> Reassembly

Left Axle Shaft Oil Seal: Reassembly

WARNING: This page does not describe the selected car, but rather 43 other vehicles, including the 2003 Pontiac Montana, 2003 Pontiac Grand Prix, 2003 Pontiac Bonneville, 2003 Pontiac Aztek, and 2003 Oldsmobile Silhouette. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: When drive axle is removed from transaxle for any reason, inspect axle sealing surface (tripot shank) for corrosion. If corrosion is evident, clean surface with 320-grit cloth or equivalent. Clean off any remaining debris with ATF. Wipe surface dry and reinstall drive axle free of any build up.

Install NEW left axle shaft oil seal onto Left Side Axle Seal Installer (J-34115). Using left side axle seal installer and mallet, install left side axle oil seal assembly. See Fig 1.

Fig 1: Installing Left Side Axle Oil Seal
G00073369Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals