LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Automatic Transaxle Overhaul & Testing - 4T65-E) >> Component Disassembly & Reassembly >> Input Shaft Oil Seal Rings >> Input Shaft Oil Seal Ring Replacement

Input Shaft Oil Seal Ring Replacement

WARNING: This page does not describe the selected car, but rather 43 other vehicles, including the 2003 Pontiac Montana, 2003 Pontiac Grand Prix, 2003 Pontiac Bonneville, 2003 Pontiac Aztek, and 2003 Oldsmobile Silhouette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove solid oil seal rings from input shaft. Inspect seal ring grooves for nicks or burrs. Lubricate each oil seal ring, and position individually onto Seal Protector (J-34741-1). See Fig 1.
  2. Quickly slide each seal into ring groove when protector is in position. Using Seal Driver (J-34741-2), push ring over seal protector. Size seal with Seal Sizer (J-34741-3). Gently twist seal sizer over each seal. Leave sizer in place until input clutch housing installation.
Fig 1: Installing & Sizing Seal Rings To Housing
G92C12734Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals