Disassembly & Reassembly

WARNING: This page does not describe the selected car, but rather 43 other vehicles, including the 2003 Pontiac Montana, 2003 Pontiac Grand Prix, 2003 Pontiac Bonneville, 2003 Pontiac Aztek, and 2003 Oldsmobile Silhouette. However, it is still accessible from the selected car via links, so may be relevant.

Using Driver Handle (J-8092), Bearing Remover (J-34129) and hammer, drive driven sprocket support bearing from support. See Fig 1. To reassemble, position driven sprocket support bearing assembly so markings on edge of bearing are facing up. Using Driver Handle (J-8092), Bearing Installer (J-34126) and hammer, seat bearing flush to or below support hub. See Fig 2.

Fig 1: Removing Driven Sprocket Support Bearing

Courtesy of GENERAL MOTORS CORP.

Fig 2: Installing Driven Sprocket Support Bearing

Courtesy of GENERAL MOTORS CORP.