LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Automatic Transaxle Overhaul & Testing - 4T65-E) >> Component Disassembly & Reassembly >> Driven Sprocket Support Assembly >> Reassembly

Driven Sprocket Support Assembly: Reassembly

WARNING: This page does not describe the selected car, but rather 43 other vehicles, including the 2003 Pontiac Montana, 2003 Pontiac Grand Prix, 2003 Pontiac Bonneville, 2003 Pontiac Aztek, and 2003 Oldsmobile Silhouette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate NEW inner and outer seal with ATF prior to installation. Install outer seal on 4th clutch piston. See Figure. Install inner 4th clutch piston seal onto driven sprocket support hub. See Figure.
  2. Install 4th clutch piston into driven sprocket support and align components. Install 4th clutch spring assembly into piston. See Figure. Using spring compressor, compress spring assembly and install snap ring. See Figure. Lubricate NEW oil seal rings for 2nd clutch housing. Install oil seal rings and 4-lobed ring seals onto driven sprocket support hub. See Figure.
scientia non olet · About LEMON Manuals