LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Automatic Transaxle Overhaul & Testing - 4T65-E) >> Component Disassembly & Reassembly >> Driven Sprocket Support Assembly >> Disassembly

Driven Sprocket Support Assembly: Disassembly

WARNING: This page does not describe the selected car, but rather 43 other vehicles, including the 2003 Pontiac Montana, 2003 Pontiac Grand Prix, 2003 Pontiac Bonneville, 2003 Pontiac Aztek, and 2003 Oldsmobile Silhouette. However, it is still accessible from the selected car via links, so may be relevant.

Using appropriate spring compressor, compress 4th clutch spring assembly. Remove snap ring from driven sprocket support assembly. See Figure. Remove spring compressor, spring assembly and 4th clutch piston from driven sprocket support assembly. Remove inner seal from driven sprocket support assembly hub. Remove oil seal rings and 4-lobed ring seals from driven sprocket support assembly. See Figure. Remove outer seal from piston. See Figure.

scientia non olet · About LEMON Manuals