LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Automatic Transaxle Overhaul & Testing - 4T65-E) >> Component Disassembly & Reassembly >> Drive Sprocket & Turbine Shaft >> Reassembly

Drive Sprocket & Turbine Shaft: Reassembly

WARNING: This page does not describe the selected car, but rather 43 other vehicles, including the 2003 Pontiac Montana, 2003 Pontiac Grand Prix, 2003 Pontiac Bonneville, 2003 Pontiac Aztek, and 2003 Oldsmobile Silhouette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Insert turbine shaft into drive sprocket and install retaining ring. See Fig 1.
  2. Install Turbine Shaft Seal Installer/Expander (J-29569-1) onto chain side of turbine shaft. Coat turbine shaft seal installer/expander with petroleum jelly. Slide turbine shaft oil seal rings into position. See Fig 4.
  3. Using Turbine Shaft Seal Installer/Compressor (J-29569-2), size chain side turbine shaft oil seal rings. See Fig 5.
  4. Install Turbine Shaft Seal Installer/Expander (J-29829-1A) onto converter side of turbine shaft. Coat turbine shaft seal installer/expander with petroleum jelly. Slide turbine shaft oil seal ring into position. See Fig 6.
  5. Using Turbine Shaft Seal Installer/Compressor (J-29829-2), size converter side turbine shaft oil seal ring. See Fig 7.
Fig 1: Removing Turbine Shaft Oil Seal Rings & Drive Sprocket
G00073359Courtesy of GENERAL MOTORS CORP.
Fig 2: Inspecting Driven Sprocket Assembly
G00073361Courtesy of GENERAL MOTORS CORP.
Fig 3: Inspecting Drive Sprocket & Turbine Shaft Assembly
G00073360Courtesy of GENERAL MOTORS CORP.
Fig 4: Installing Turbine Shaft Oil Seal Rings (Chain Side)
G00073362Courtesy of GENERAL MOTORS CORP.
Fig 5: Sizing Turbine Shaft Oil Seal Rings (Chain Side)
G00073363Courtesy of GENERAL MOTORS CORP.
Fig 6: Installing Turbine Shaft Oil Seal Rings (Converter Side)
G00073364Courtesy of GENERAL MOTORS CORP.
Fig 7: Sizing Turbine Shaft Oil Seal Rings (Converter Side)
G00073365Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals