LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Automatic Transaxle Overhaul & Testing - 4T65-E) >> Component Disassembly & Reassembly >> Case Cover Components >> Bearing Replacement

Bearing Replacement

WARNING: This page does not describe the selected car, but rather 43 other vehicles, including the 2003 Pontiac Montana, 2003 Pontiac Grand Prix, 2003 Pontiac Bonneville, 2003 Pontiac Aztek, and 2003 Oldsmobile Silhouette. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: When installing NEW bearing, part number should be visible (facing upward).

Place case cover on clean flat surface with spacer plate mating surface up. Using Driver Handle (J-8092), Bearing Remover/Installer (J-41991) and hammer, drive out bearing from case cover. See Figure. To install, place case cover on clean flat surface with case mating surface up. Drive bearing into case cover. See Figure.

scientia non olet · About LEMON Manuals