LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Automatic Transaxle Overhaul & Testing - 4T65-E) >> Component Disassembly & Reassembly >> Accumulator Components >> Disassembly

Accumulator Components: Disassembly

WARNING: This page does not describe the selected car, but rather 43 other vehicles, including the 2003 Pontiac Montana, 2003 Pontiac Grand Prix, 2003 Pontiac Bonneville, 2003 Pontiac Aztek, and 2003 Oldsmobile Silhouette. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: DO NOT mix up springs or pistons. Be sure to install correct springs in correct bore.
  1. Remove 7 remaining accumulator cover bolts from accumulator assembly. Remove accumulator cover and spacer plate from accumulator housing. Disassemble 1-2 and 2-3 accumulator pistons, piston pins, outer springs and cushion springs from accumulator housing (springs are model dependent). Remove piston oil seal rings from 1-2 and 2-3 accumulator pistons. See Figure.
  2. Disassemble 2-1 manual band servo and forward band servo oil pipes, lube oil pipe assembly from accumulator cover, and 2-1 manual band servo cover. Disassemble lube oil pipe, hose clamps, oil hose, lube oil pipe retainer and lube oil pipe with washer. See Figure.
scientia non olet · About LEMON Manuals