LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 348 (Servicing - A/T (VT25-E)) >> Removal & Installation >> Control Valve Body Cover >> Removal

Control Valve Body Cover: Removal

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove battery cover. Disconnect negative battery cable. Disconnect positive battery cable. Loosen battery hold-down screw and remove battery. See Figure .
  2. Remove battery cooling box. See BATTERY COOLING BOX  .
  3. Loosen battery tray bracket screws and remove bracket. See Figure .
  4. Disconnect transaxle harness connector. See Fig 1 .
  5. Remove transaxle vent cap.
  6. Remove bolts from control valve body cover. Remove control valve body cover.
  7. Remove control valve body cover gasket and discard. See Fig 2 .
Fig 1: Disconnecting Transaxle Harness Connector
G00078056Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing & Installing Valve Body Cover
G00078055Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals