LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 348 (Servicing - A/T (VT25-E)) >> Removal & Installation >> Battery Cooling Box >> Removal

Battery Cooling Box: Removal

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: DO NOT tip battery over 45 degree angle or acid could spill.
NOTE: Record all pre-set radio stations prior to disconnecting battery and reprogram pre-set stations after repair.
  1. Turn the ignition off.
  2. Loosen the battery cover screws and remove the battery cover.
  3. Disconnect the negative battery cable.
  4. Disconnect the positive battery cable.
  5. Remove the battery hold down bolt and remove the battery. See Fig 1 .
  6. Remove the Underhood Fuse Block (UHFB) cover.
  7. Remove the positive battery cable and Electronic Power Steering (EPS) wire from "B" positive terminal at UHFB.
  8. Open all retainer clips and remove all cables, lines and harnesses from the battery cooling box.
  9. Remove the UHFB connector retaining bolts.
  10. Unfasten the UHFB from its housing and disconnect the forward lamp harness.
    NOTE: Protect the disconnected harness from contamination during service.
  11. Remove the battery cooling box bolts. See Fig 2 .
  12. Remove the battery cooling box side support bolt.
  13. Pull the inlet duct away from the battery cooling box. See Fig 3 .
  14. Rotate the UHFB out of the way and remove the battery cooling box.
Fig 1: Removing & Installing Battery Hold Down Screw
G00078048Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing & Installing Underhood Fuse Box
G00078049Courtesy of GENERAL MOTORS CORP.
Fig 3: Removing Inlet Duct
G00203005Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals