Diagnostic Procedures
WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Did you perform the Diagnostic System Check - Engine Controls? If yes, go to next step. If no, go to DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS .
- Are DTCs P0121, P0122, P0123, P0221, P0222, P0223, P0638, P1551, P2100, P2101, P2107, P2119, P2122, P2123, P2127, P2128, P2135, P2138, or P2176 also set? If yes, see DIAGNOSTIC TROUBLE CODE DEFINITIONS . If no, go to next step.
- Replace ECM. Perform ECM relearn procedures. See ENGINE CONTROL MODULE under PROGRAMMING. After replacing ECM, go to next step.
- Clear the DTCs with a scan tool. Turn ignition off for 30 seconds. Start engine. Operate vehicle within the Conditions for Running the DTC. See CONDITIONS FOR RUNNING DTC . You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records. Did the DTC fail this ignition? If yes, go to step 2. If no, go to next step.
- Observe the Capture Info with a scan tool. Are there any DTCs that have not been diagnosed? If yes, diagnose affected DTC(s). See DIAGNOSTIC TROUBLE CODE DEFINITIONS . If no DTCs are displayed, system is okay.