Clutch Master Cylinder & Reservoir: Removal
WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Disconnect the clutch pedal position switch electrical connector. Push the clutch pedal in and squeeze the pushrod bushing tabs in, in order to release the pushrod bushing from the clutch pedal. If equipped with a NV 3500 or NV 4500 transmission, disconnect the clutch actuator cylinder to clutch master cylinder quick connect fitting. Remove the clutch master cylinder clip from the brake pressure module valve pipe. If equipped with a ZF S6-650 transmission, disconnect the clutch actuator cylinder to clutch master cylinder quick connect fitting. Rotate the clutch master cylinder 45 degrees clockwise to the unlocked position. See Figure .