LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Wheel Alignment Specifications & Adjustment Procedures) >> Wheel Alignment Procedures >> Camber & Caster Adjustment >> "C", "G" & "K" Series Except 1999 Sierra & Silverado C1500 & C2500 (Caster Adjustment)

"C", "G" & "K" Series Except 1999 Sierra & Silverado C1500 & C2500 (Caster Adjustment)

WARNING: This page does not describe the selected car, but rather 64 other vehicles, including the 1999 Pontiac Montana, 1999 Oldsmobile Silhouette, 1999 Oldsmobile Bravada, 1999 GMC Yukon, and 1999 GMC Suburban. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check frame angle. See "C", "G", "K" & "P" (FRAME ANGLE)  . If corrected caster is not within specification, remove frame bracket slots. See "C", "G" & "K" SERIES (FRAME BRACKET SLOT REMOVAL)  . Reset caster by loosening nut on end of each cam bolt securing upper control arm to frame brackets. See Figure .
  2. Rotate cam bolts until caster is within specification. See WHEEL ALIGNMENT SPECIFICATIONS  table. Tighten nuts to specification. See TORQUE SPECIFICATIONS  table.
scientia non olet · About LEMON Manuals