LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 286 (Automatic Transmission Servicing - ALLISON LCT 1000) >> Removal & Installation >> Pressure Switch Manifold >> Installation

Pressure Switch Manifold: Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, 2004 Chevrolet Cab & Chassis Silverado, and 2003 GMC Sierra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the new pressure switch manifold assembly (2) in position and install one bolt (1) in a recessed location to hold it into position. See Figure .
  2. Start the remaining 4 bolts (1) in recessed locations and tighten the bolts by hand. Tighten the bolts to specification. See TORQUE SPECIFICATIONS  .
  3. Connect the internal wiring harness connector to the pressure switch assembly.
  4. Install the reverse signal tube (1). Install 2 bolts (2). Tighten the bolts to specification. See TORQUE SPECIFICATIONS  .
  5. Install the oil pan and suction filter. See INTERNAL FILTER  under LUBRICATION.
scientia non olet · About LEMON Manuals