LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 286 (Automatic Transmission Servicing - ALLISON LCT 1000) >> Removal & Installation >> Filler Tube & Seal >> Removal

Filler Tube & Seal: Removal

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, 2004 Chevrolet Cab & Chassis Silverado, and 2003 GMC Sierra. However, it is still accessible from the selected car via links, so may be relevant.
  1. The transmission case has provisions that enable the fill tube to be installed on either the right or left side of the transmission. If servicing the plug and/or seal opposite the fill tube, go to step  8 .
  2. Remove the transmission fluid level indicator.
  3. Raise and suitably support the vehicle.
  4. Remove the nuts attaching the fill tube to the transmission. See Fig 1 .
  5. Place a drain pan under the transmission to catch any dripping fluid.
  6. Loosen the fill tube from the transmission.
  7. Remove the fill tube and seal from the vehicle.
  8. Remove the fill tube plug (1). See Fig 2 .
  9. Remove the fill tube plug seal (2).
Fig 1: Disconnecting & Connecting Filler Tube Bracket
G00096133Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing & Installing Filler Tube Seal & Plug
G00096134Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals