LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 286 (Automatic Transmission Servicing - ALLISON LCT 1000) >> Lubrication >> Checking Fluid Level & Condition >> Checking Level (Hot)

Checking Level (Hot)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, 2004 Chevrolet Cab & Chassis Silverado, and 2003 GMC Sierra. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The fluid must be hot to ensure an accurate check. The fluid level rises as temperature increases.
  1. Operate the transmission in Drive range until normal operating temperature is reached. Normal operating temperature is indicated by a sump temperature of 160-200°F (71-93°C) or a converter-out temperature of 180-220°F (82-104°C). If a transmission temperature gauge is not present, check fluid level when the engine water temperature gauge has stabilized and the transmission has been operated under load for at least one hour.
  2. Bring the vehicle to a complete stop on a level surface using the service brake.
  3. Ensure the engine is at low idle RPM (500-800 RPM).
  4. With the service brakes applied, put the transmission in the Park position.
  5. Engage the park pawl by slowly releasing the service brakes. The vehicle may move slightly as the pawl engages.
  6. Apply the parking brake and make sure it is properly engaged.
  7. With the engine running, remove the fluid level indicator from the fill tube and wipe the indicator clean.
    NOTE: Always check the fluid level at least twice using the procedure described above. Consistent readings are important to maintaining proper fluid level. If inconsistent readings persist, check the transmission vent assembly to ensure it is clean and unclogged. If readings are still inconsistent, contact your nearest Allison distributor or dealer.
  8. Insert the fluid level indicator into fill the tube and remove. Check fluid level reading. Repeat the check procedure to verify the reading.
    NOTE: Safe operating level is within the "HOT RUN" band on the fluid level indicator. The width of the "HOT RUN" band represents approximately 1.06 qts. (1.0L) of fluid at normal operating sump temperature.
  9. If the fluid level is not within the "HOT RUN" band, add or drain as necessary to bring the fluid level to within the "HOT RUN" band.
scientia non olet · About LEMON Manuals