LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Computer Relearn Procedures) >> Relearn Procedures (Cars) >> Century, Grand PRIX, Intrigue, Lumina, Monte CARLO & Regal >> Programming New Theft Deterrent Module (Lumina)

Programming New Theft Deterrent Module (Lumina)

WARNING: This page does not describe the selected car, but rather 67 other vehicles, including the 2000 Saturn SW2, 2000 Saturn SL2, 2000 Saturn SL1, 2000 Saturn SL, and 2000 Saturn SC2. However, it is still accessible from the selected car via links, so may be relevant.
  1. With new theft deterrent module installed and connected, insert customer's key into ignition key lock cylinder and turn ignition switch to RUN position. New modules are programmed to store first pellet resistance detected. Start engine to verify system operation. If engine starts, go to next step. If engine does not start, diagnose and repair anti-theft system. See ANTI-THEFT SYSTEMS - LUMINA article under ACCESSORIES & EQUIPMENT.
  2. Observe SECURITY indicator light. Indicator light should illuminate for about 5 seconds and go out. This indicates module programming has been successfully completed. If indicator light flashes once per second and engine starts, module did not program. Check wiring, connectors, contacts to key resistance pellet, and key for defects or intermittents. Repair or replace as necessary and repeat programing procedure.
scientia non olet · About LEMON Manuals