LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Computer Relearn Procedures) >> Relearn Procedures (Cars) >> Century, Grand PRIX, Intrigue, Lumina, Monte CARLO & Regal >> PASS-Key(R) III System Auto Learn Procedure (Grand Prix)

PASS-Key(R) III System Auto Learn Procedure (Grand Prix)

WARNING: This page does not describe the selected car, but rather 67 other vehicles, including the 2000 Saturn SW2, 2000 Saturn SL2, 2000 Saturn SL1, 2000 Saturn SL, and 2000 Saturn SC2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Insert a valid mechanical coded unlearned master ignition key (Black) in the ignition switch. Place ignition switch in RUN position. The SECURITY indicator light will flash once per second for 10 minutes for the length of the auto learn timer.
  2. When auto learn timer expires and SECURITY indicator light goes off, place ignition switch in LOCK position. Wait 5 seconds.
  3. Repeat steps 1) and 2)  2 more times. Insert the newly learned ignition key in ignition switch.
  4. Place ignition switch in RUN position. The SECURITY indicator light should remain off to indicate that ignition key was learned. This will be the only learned key. To program more keys, see PASS-KEY(R) III SYSTEM QUICK LEARN PROCEDURE (GRAND PRIX). If security indicator does not remain off, repeat procedure. Use scan tool to clear any DTCs.
NOTE: PASS-Key(R) III system quick learn procedure is used to learn additional ignition keys. A learned key must be used to initiate procedure. Up to 10 ignition keys can be learned.
scientia non olet · About LEMON Manuals