LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 275 (Automatic Transmission - 4L60-E/4L65-E - Servicing) >> Removal & Installation >> Shift Cable >> Removal

Shift Cable: Removal

WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 2004 GMC Yukon XL, 2004 GMC Yukon, 2004 GMC Sierra, 2004 Chevrolet Tahoe, and 2004 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the steering column shift lever to the Park position.
  2. Remove the instrument panel knee bolster.
  3. Remove the driver's seat.
  4. Pull back the carpet and insulation around the driver's area.
  5. Remove the retainer securing the cable to the steering column. See Fig 1 .
  6. Remove the cable end from the steering column ball stud. See Fig 2 .
  7. Depress the tangs and remove the cable from the steering column bracket.
  8. Remove the bolt securing the cable support to the brace. See Fig 3 .
    NOTE: Avoid unnecessary twisting/bending of the range selector cable when removing the cable from the support.
  9. Remove the range selector cable from the support. See Fig 4 .
  10. Remove the cable grommet from the floor panel. See Fig 5 .
  11. Raise and suitably support the vehicle.
  12. Remove the clips on the cable from the floor panel reinforcement. See Fig 6 .
  13. Ensure the transmission manual shaft is positioned in mechanical Park.
  14. Remove the retainer that secures the cable to the bracket. See Figure .
  15. Remove the cable clip on the transfer case, if equipped.
  16. Remove the range selector cable end (2) from the transmission range selector lever ball stud (1). See Fig 7 .
  17. Depress the tangs and remove the cable from the bracket.
  18. Lower the vehicle and ensure that the steering column shift lever is still in the Park position.
Fig 1: Removing Retainer Securing Cable To Steering Column
G00202985Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing Cable From Steering Column Ball Stud
G00202986Courtesy of GENERAL MOTORS CORP.
Fig 3: Removing & Installing Cable Support
G00096126Courtesy of GENERAL MOTORS CORP.
Fig 4: Removing & Installing Shift Cable At Support
G00096127Courtesy of GENERAL MOTORS CORP.
Fig 5: Removing Cable Grommet From Floor Panel
G00202987Courtesy of GENERAL MOTORS CORP.
Fig 6: Removing Floor Panel Reinforcement Clips
G00202988Courtesy of GENERAL MOTORS CORP.
Fig 7: Removing & Installing Shift Cable At Transmission Lever
G00092163Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals