LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 275 (Automatic Transmission - 4L60-E/4L65-E - Servicing) >> Removal & Installation >> Park/Neutral Position Switch >> Removal

Park/Neutral Position Switch: Removal

WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 2004 GMC Yukon XL, 2004 GMC Yukon, 2004 GMC Sierra, 2004 Chevrolet Tahoe, and 2004 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply the Parking brake.
  2. Shift the transmission into Neutral.
  3. If equipped with 4WD, remove the front drive shaft. See appropriate DRIVE SHAFTS & UNIVERSAL JOINTS article in DRIVELINE/AXLES.
  4. Raise and suitably support the vehicle.
  5. Disconnect the Park/Neutral Position (PNP) switch electrical connectors (2). See Fig 1 .
  6. Remove the manual shaft lever nut. See Fig 2 .
  7. Remove the transmission control lever from the manual shaft.
  8. Remove the PNP switch bolts.
  9. Remove the PNP switch from the manual shaft. If the PNP switch did not slide off the manual shaft, file the outer edge of the manual shaft in order to remove any burrs.
Fig 1: Disconnecting PNP Switch Electrical Connector
G00202983Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing & Installing Park/Neutral Position Switch
G00089910Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals