LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 275 (Automatic Transmission - 4L60-E/4L65-E - Servicing) >> Removal & Installation >> Extension Housing Rear Oil Seal >> Installation

Extension Housing Rear Oil Seal: Installation

WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 2004 GMC Yukon XL, 2004 GMC Yukon, 2004 GMC Sierra, 2004 Chevrolet Tahoe, and 2004 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the inside diameter of the NEW seal with Transjel(R) lubricant.
  2. Install the new seal using rear extension seal installer and a soft faced mallet. See Fig 1 .
  3. Remove the drain pan.
  4. Install the drive shaft. See appropriate DRIVE SHAFTS & UNIVERSAL JOINTS article in DRIVELINE/AXLES.
  5. Fill transmission with appropriate fluid to proper level. See LUBRICATION  .
Fig 1: Installing Rear Extension Housing Rear Oil Seal
G00088372Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals