LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 275 (Automatic Transmission - 4L60-E/4L65-E - Servicing) >> Lubrication >> Oil Cooler Flushing & Flow Check >> Preparation

Oil Cooler Flushing & Flow Check: Preparation

WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 2004 GMC Yukon XL, 2004 GMC Yukon, 2004 GMC Sierra, 2004 Chevrolet Tahoe, and 2004 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
  1. After the repair or replacement transmission is installed in the vehicle, DO NOT reconnect the oil cooler pipes.
  2. Remove the fill cap (9) on the Transmission Oil Cooler and Line Flusher (J-35944-A) and fill the flusher tank (4) with 20-21 oz. (0.6L) of flushing solution using the measuring cup (6). DO NOT overfill.
  3. Install the fill cap (9) on the flusher and pressurize the flusher tank (4) to 80-100 psi (550-700 kPa), using the shop air supply at the tank air valve (9). See Fig 1 .
  4. With the water supply valve (1) on the flusher in the OFF position, connect the water supply hose (7) from the flusher to the water supply at the faucet. See Fig 1 and Fig 2 .
  5. Turn ON the water supply at the faucet.
Fig 1: Identifying Flushing Equipment
G00056982Courtesy of GENERAL MOTORS CORP.
Fig 2: Connecting Flushing Equipment
G00056983Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals