LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 275 (Automatic Transmission - 4L60-E/4L65-E - Servicing) >> Lubrication >> Draining & Refilling >> Refilling & Inspecting

Refilling & Inspecting

WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 2004 GMC Yukon XL, 2004 GMC Yukon, 2004 GMC Sierra, 2004 Chevrolet Tahoe, and 2004 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
  1. Coat the NEW filter seal with automatic transmission fluid.
  2. Install the NEW filter seal into the transmission case. Tap the seal into place using a suitable size socket. See Fig 1 .
  3. Install the NEW filter.
  4. Install the oil pan and NEW gasket. See Figure .
  5. Install the oil pan bolts. See Figure . Tighten the bolts alternately and evenly to specification. See TORQUE SPECIFICATIONS  .
  6. If previously removed, install the range selector cable bracket and bolts. Tighten the bolts to specification. See TORQUE SPECIFICATIONS  .
  7. Apply a small amount of sealant to the threads of the oil pan drain plug, if equipped.
  8. Install the oil pan drain plug, if equipped. Tighten the plug to specification. See TORQUE SPECIFICATIONS  .
  9. Lower the vehicle.
  10. Fill transmission to proper level with appropriate fluid. See RECOMMENDED FLUIDS  and FLUID CAPACITIES  .
  11. Check the COLD fluid level reading for initial fill only.
  12. Inspect the oil pan gasket for leaks.
Fig 1: Installing Filter Seal
G00202965Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals