LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 274 (Engine Controls - Self-Diagnostics - 2.2L) >> Diagnostic Tests >> DTC P0507: Idle Speed High - IAC Responding >> Diagnostic Procedures

Diagnostic Procedures

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform diagnostic system check - engine controls. See DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS  under SELF-DIAGNOSTIC SYSTEM. After performing diagnostic system check - engine controls, go to next step.
  2. Start engine. Command the engine speed up to 1500 RPM, down to 500 RPM, and up to 1500 RPM with a scan tool. Exit the RPM control function. Does the engine speed correspond within 100 RPM with each command? If yes, problem is intermittent. See INTERMITTENTS in TROUBLE SHOOTING - NO CODES - 2.2L & 3.0L VUE article. If no, go to next step.
  3. Inspect for vacuum leaks, excessive deposits in the throttle body or a faulty PCV valve. Repair as necessary. After repairs, go to next step.
  4. Using scan tool, clear DTCs. Turn ignition off for 30 seconds. Operate vehicle within the conditions for running the DTC. See CONDITIONS FOR RUNNING DTC . You may also operate vehicle within the conditions observed from the Freeze Frame/Failure Records. Did the DTC fail this ignition? If yes, go to step  2. If no, go to next step.
  5. With a scan tool, observe the stored information, Capture Info. Does the scan tool display any DTCs that you have not diagnosed? If yes, see DIAGNOSTIC TROUBLE CODE DEFINITIONS . If no, system is okay.
scientia non olet · About LEMON Manuals