LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 273 (Automatic Transmission Servicing) >> Removal & Installation >> Transaxle Mount & Bracket >> Removal

Transaxle Mount & Bracket: Removal

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Remove the left front tire and wheel. Remove the left inner splash shield.
  2. Use a utility stand with a block of wood in order to support the transaxle. Remove the transaxle mount upper nuts. See Fig 1 .
  3. Remove the transaxle bracket to transaxle mount upper nuts. See Fig 1 . Remove the transaxle mount bracket bolts. Remove the transaxle mount bracket. See Fig 2 .
  4. Remove the transaxle mount lower nuts to the transaxle mount frame bracket. Remove the transaxle mount from the transaxle mount frame bracket.
Fig 1: Removing & Installing Transaxle Upper Mount Nuts
G00087730Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing & Installing Transaxle Bracket Bolts
G00087731Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals