LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 272 (Drive Axles - QUADRASTEER) >> Removal & Installation >> Propeller Shaft Replacement - One Piece >> Installation

Propeller Shaft Replacement - One Piece: Installation

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 GMC Sierra, 2003 Chevrolet Tahoe, and 2003 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the splines of the slip yoke for a sufficient coating of grease. If the splines of the slip yoke does not have a sufficient coating of grease, lubricate the shaft with grease, GM P/N 12345879 or equivalent, RWD w/ Automatic Transmission Only.
  2. Install the propeller shaft into the transmission or transfer case. Align the reference marks made during removal.
  3. Install the propeller shaft (3) to the rear axle pinion yoke (4). Align the reference marks made during removal.
  4. Install the yoke retainers (2) and bolts (1). Tighten to Specifications.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals