LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 271 (Power Sun Roof) >> Repair Instructions >> Sunroof Glass Height and Opening Fit Adjustment >> Adjustment of the Sunroof Glass Panel Seal

Adjustment of the Sunroof Glass Panel Seal

WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.

The sunroof glass panel seal controls the entry of water to the drain channels. If the sunroof glass panel is correctly adjusted, the fit between the weatherstrip and the roof will be snug.

Complete the following steps in order to test the fit:

  1. Insert a piece of paper between the roof and the weatherstrip.
  2. Close the glass panel.
  3. Pull out the paper.

    If there is some resistance when you pull out the paper, the fit is correct. Proper adjustment is necessary to ensure that the amount of water to the sunroof drain hoses is not excessive. An improper fit may cause water leaks or objectionable wind noise.

  4. Complete all of the glass panel to roof adjustments by changing the vertical height and centering of the glass panel.