LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Drive Axles) >> Overhaul >> Differential Case >> Removing Drive Pinion Cartridge

Removing Drive Pinion Cartridge

WARNING: This page is about a different car, the 2003 Chevrolet Corvette and 2002 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the pinion nut using the Bearing Race Installer/Spanner Wrench (J 42172) and the Pinion Gear Holder (J 42164). See Fig 1.
    Fig 1: Removing/Installing Pinion Shaft Nut
    G00061885Courtesy of GENERAL MOTORS CORP.
  2. Position the pinion housing/cage into a press. Use the Side Gear Compressor (J 42162) and a hydraulic press in order to remove the pinion shaft and bearing from the housing/cage.
  3. Remove the nut, bearing, spacer, and pinion shaft from the housing/cage. See Figure.
  4. Install the Front Pinion Bearing Remover (J 42166) onto the pinion shaft and bearing. Use the J 42162, J 42166, and a hydraulic press in order to remove the bearing from the shaft.
  5. Use the Bearing Race Remover (J 42194) and a hydraulic press in order to remove the bearing race from the housing/cage. Use the J 42194 and a hydraulic press in order to remove bearing race from the housing/cage.
scientia non olet · About LEMON Manuals