LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 264 (Automatic Transaxle Removal & Installation) >> Removal & Installation >> Engine Mount Strut Bracket-To-Upper Radiator Support >> Installation (3.1L)

Installation (3.1L)

WARNING: This page is about a different car, the 2003 Buick Regal, 2003 Buick Century, 2002 Buick Regal, and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the engine mount strut bracket over the upper radiator support. Make sure that the engine mount strut bracket and the engine mount strut are aligned to the proper holes of the upper radiator support (1 and 2). See Fig 1 for proper torque sequence.
    Fig 1: Identifying Engine Mount Strut & Bracket Proper Torque Sequence
    G00199812Courtesy of GM
  2. Install and tighten the engine mount strut bracket bolts. The following is a mandatory torque sequence:
    1. Horizontal engine mount strut bracket bolt (1). See TORQUE SPECIFICATIONS  .
    2. Vertical engine mount strut bracket bolt (2). See TORQUE SPECIFICATIONS  .
  3. Install the engine mount strut to the engine mount strut bracket at the upper radiator support. See Fig 1 . See ENGINE MOUNT STRUT BRACKET  .
scientia non olet · About LEMON Manuals