LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 263 (Instrument Panel, Gauges & Console) >> Repair Instructions >> Lock Cylinder Replacement - I/P Compartment Door >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the instrument panel compartment latch fork bolt in the up position.
  2. Grasp the instrument panel compartment lock cylinder. Depress the rear-most, light-colored tumbler that is flush with the instrument panel compartment lock cylinder surface.
  3. Insert the key.

    All the tumblers will now stay depressed.

  4. Insert the instrument panel compartment lock cylinder, with the key inserted, into the instrument panel compartment latch housing. Ensure that the front projection pin is at the appropriate 8 o'clock position.
    5. Fig 1: Installing Compartment Door Lock Cylinder Into Latch Housing
    G01755290Courtesy of GENERAL MOTORS CORP.
  5. The instrument panel compartment lock cylinder will drop into place.
  6. Rotate the key counterclockwise until the key stops.
  7. Remove the key, the tumblers will now release.

    The instrument panel compartment lock cylinder is now locked into the instrument panel compartment latch housing.

  8. Install the instrument panel compartment latch. Refer to Latch Replacement - I/P Compartment .
scientia non olet · About LEMON Manuals