Removal Procedure

WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.

Important: The ignition switch must be in the OFF position when removing the instrument panel cluster (IPC).

Remove the cluster trim plate. Refer to Trim Plate Bezel Replacement - I/P Cluster .
Remove the screws from the IPC.

Fig 1: Identifying Instrument Panel Cluster (IPC)

Courtesy of GENERAL MOTORS CORP.

In order to remove the IPC, perform the following procedures:
1. 3.1. Rotate the top of the cluster rearward.
2. 3.2. Disengage the locating pins on the bottom of the cluster.
Disconnect the electrical connector from the cluster.

Fig 2: Identifying Instrument Panel Cluster (IPC) Electrical Connector
Courtesy of GENERAL MOTORS CORP.