LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 263 (Instrument Panel, Gauges & Console) >> Repair Instructions >> Filler Panel Replacement - Outer - I/P Lower Trim >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the filler panel retainers into the openings in the trim pad.
    2. Fig 1: Installing Filler Panel
    G01755273Courtesy of GENERAL MOTORS CORP.
  2. Starting at the bottom, install the filler panel by pressing in at each retainer location until correctly seated.
    NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  3. Install the filler panel bolt. Tighten the bolt to 2 N.m (18 lb in).
    4. Fig 2: Identifying Filler Panel Bolt
    G01755274Courtesy of GENERAL MOTORS CORP.
  4. Close the I/P compartment.
scientia non olet · About LEMON Manuals