LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 257 (Engine Mechanical - 4.0L (On-Vehicle)) >> Repair Instructions >> Camshaft Intermediate Drive Shaft Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the camshaft intermediate drive shaft sprocket. Refer to Primary Camshaft Drive Chain and Sprockets Replacement .

    Important:  The camshaft intermediate drive shaft should not be removed unless wear is evident.

  2. Remove the camshaft intermediate drive shaft retaining bolts.
  3. Remove the camshaft intermediate drive shaft (1) from the engine.
    Fig 1: Removing Camshaft Intermediate Drive Shaft
    G01819428Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals