LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 256 (Engine Controls - Basic Diagnostic Procedures - 2.2L) >> Ignition Systems >> Electronic Ignition System Diagnosis Without Special Tool >> Crankshaft Position (CKP) Sensor Output Signal

Crankshaft Position (CKP) Sensor Output Signal

WARNING: This page is about a different car, the 2003 Pontiac Sunfire, 2003 Pontiac Grand Am, 2003 Oldsmobile Alero, and 2003 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.

Set DVOM on 2-volt AC scale. Connect DVOM leads to CKP sensor located on side of engine block. Crank engine and observe voltmeter reading. CKP sensor should generate a voltage signal of about 2 volts.

scientia non olet · About LEMON Manuals