LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 253 (Engine Controls - System & Component Tests - 2.2L) >> Emission Systems & Sub-Systems >> Evaporative Emission System Cleaning >> Cleaning Procedure

Cleaning Procedure

WARNING: This page is about a different car, the 2003 Pontiac Sunfire, 2003 Pontiac Grand Am, 2003 Oldsmobile Alero, and 2003 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Remove the EVAP canister.
  3. Turn OFF the main valve on the EVAP Pressure and Purge Station.
  4. Disconnect the hose from the diagnostic station pressure regulator.
  5. Using a section of vacuum hose, connect one end onto the diagnostic station pressure regulator.
  6. Connect the other end of the vacuum hose to the canister side of the purge pipe.
  7. Turn ON the main nitrogen cylinder valve and continue to discharge nitrogen for 15 seconds.
  8. If the nitrogen does not dislodge the carbon particles, replace the purge pipe.
  9. Return the EVAP pressure/purge diagnostic station to the original condition of the station.
  10. Install a new EVAP canister.
  11. Lower the vehicle.
  12. Install a new EVAP canister purge valve.
  13. Return to the published service procedure.
scientia non olet · About LEMON Manuals